Installing a Cinderella incineration toilet is straightforward, providing a reliable and off-grid-ready sanitation solution built to last for years. To ensure optimal performance and keep your warranty valid, always follow the detailed instructions included in the product manual.
What You Need for a Complete Installation
A complete setup requires the Cinderella incineration toilet itself (along with model-specific components included in the toilet box) plus the universal installation kit, which arrives in two boxes:
- Installation Kit – Box 1:
- 1x black air inlet grate,
- 1x flue terminal cap
- 1x 87-degree elbow
- 3x pipe clamps/fasteners
- Universal installation kit quick guide.
- Installation Kit – Box 2:
- 6x UV-stabilised ventilation pipes with sockets (1000 mm / 39.37 in).
- 6x UV-stabilised ventilation pipes with sockets (1000 mm / 39.37 in).
Step-by-Step Installation Overview
1. Location Selection
- Cinderella toilets carry an IP34 rating, making them fully approved for wet rooms and unheated spaces like cabins, tiny homes, and sheds.
- Place the toilet on a flat, solid surface (tile, concrete, or wood – avoid carpets). Floor heating is completely fine.
- No floor bolting is required; leaving the unit unattached simplifies routine maintenance.
2. Fresh Air Supply
- Cinderella Comfort & Premium: Utilise a dedicated air intake pipe connected directly to the toilet unit.
- Cinderella Classic & Freedom: Require an external wall vent (min. 145 x 145 mm or Ø 160 mm round). Position vents close to the unit to minimize drafts, and avoid using mosquito nets as they restrict essential airflow.
3. Exhaust Venting & Flue Cap
- Venting Routes: Choose either an interior installation (running vertically up through the roof) or exterior installation (running horizontally through an exterior wall, then vertically past the roofline).
- Piping Rules: The vent pipe must run straight vertically from the elbow. Up to two 45° bends (max 1 meter apart) are permitted for electric models, but the gas-powered Freedom model must be vented straight up with no additional bends.
- Roof Clearance: The exhaust pipe must extend at least 60 cm (24 inches) above its exit point on the roof.
4. Power & Connections
- Electric Models (Classic, Comfort, Premium): Require a dedicated, grounded 10A wall circuit.
- Gas Model (Freedom): Connects to a standard propane gas cylinder or tank alongside a 12V battery (min. 50 Ah) or solar system. Always adhere to local Australian gas regulations during setup.
Need Technical Support or Project Advice?
If you have questions about specific building layouts or off-grid setups, contact Scandinavian Eco Solutions, your authorised Australian Cinderella distributor.